KG reg 10445/1101 Print02/1101 kithara6_configuration Ersteller: BAUMEISTER Seite 2 von 2 Erstelldatum: :29 With the Add programs it is possible to add the *.exe of the software that you have chosen. (Settings Control Panel»Kithara Control Center«Register-sheet✽OS Enabler«) 2) Following you will see 2 Screen-Shots where the configurations are explained step by step These Settings are based on the standard parameters of COM1 Interface (Base address 03f8, Interrupt 4)Ģ Settings: by Systeme Lauer GmbH & Co. The lower area manages the combining of the chosen application with the ressources that you release. Important is the register» DOS Enabler «with register-sheet» I / O Ports «to configure your individual port access. KG reg 10445/1101 Print02/1101 kithara6_configuration Ersteller: BAUMEISTER Seite 1 von 1 Erstelldatum: :29 The✽OS Enabler«supports the following Windows-Operating Systems: - Windows NT Windows 2000 First you have to uninstall older Kithara-Versions (5.xx )! Generell procedure: - Disable Dos-Enabler 5.xx: Settings Control Panel»Kithara Control Center«register-sheet»Options«disable» Use virtual 16 bit device drive «Accept Reset Kernel - Uninstall Dos-Enabler 5.xx - Reboot your System - Install Version Configurations, see 1) 1) First you have to configure your Kithara» Control Center «to run the» DOS Enabler «for special 16-Bit-Application like PCSPRO. 1 A) KITHARA DOS-ENABLER 6.0 B) Screen Mode Configuration Notice for PCSPRO / LCAPRO No Mouse Support A ) KITHARA DOS ENABLER 6.0 by Systeme Lauer GmbH & Co.
0 kommentar(er)
